INSTALLATION REQUIREMENTS
Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with any
tools listed here.
All Installations
Toolsneeded:
P ors Flat-blade
• screwdriver
5/_6"and 1/4" _ _tedlCSA --
nut drivers or _._ Approved twist-on _
hex sockets _ wire connectors*
10 adjustab e wrench %" n n
." " h _ ope -e d
that opens to _JJ_"-" wrn^h ._/CJ"
1 _ L,
1V=' (2 9 cm) _,
*Must be the proper size to connect your household winng
to 16-gauge wiring in dishwasher.
Other useful items you may need:
Shallow Bath
pa towel -_J" !
Parts supplied:
Drain hose
clamps (2)
(1 large and
1 small)
Drain
hose
#10 x W' Undercounter
PhiSps-head mounting
screws (2) brackets (2)
Make sure all these parts are included in the literature package.
t®TORX and T20 are registered trademarks of Saturn Fasteners, Inc.
Parts needed:
3AComprx 3Ahose fltt!ng
For part or kit, see local
retailer or call Whirlpool
Parts: 1,800-442-9991. Pa rt
Number W10273460
Other parts you may also need:
I !I/='L2 ' I Masking or Moisture
(3,8!-5 cm} I duct tape bardertape f_/_!
Sc[ew:type .... I I(Part Number Jj/ I
damps (3 maximum) 4396277) _!
NOTE: Parts available for purchase in plumbing supply stores.
Check local codes. Check existing electrical supply. See
"Electrical Requirements" section. It is recommended that
electrical connections be made by a licensed electrical installer.
In addition, for first-time installations
Tools needed:
IW ith 1/2 -[;L
land 1W' hole _) Small
I Saw bits _ tubing Cutter wire stripper I
Parts needed:
Copper tubi!g (3/8" see "EleCtrical Requirements" section,
O.D.suggested)0r i .. : i .. .. ,
flexible braidecl For uirectwire: For _-ower buppw
w I lin use UL Listed/ Cord" use UL
ater supp y e
CSA Approved Listed/CSA
I strain relef I Approved power
(,ttLkk£._ _)j_).)));) I to fit %, (2.2 Cm) Supply c0rd kit
hole marked for use with
diShWasher
To Next Page
Loading...
