To Next PageTo Next Page
Need help?Do you have a question about the Maytag MDE/MDG21PDA and is the answer not in the manual?
General| Brand | Maytag |
|---|---|
| Capacity | 7.0 cu. ft. |
| Color | White |
| Width | 29 inches |
| Wrinkle Prevention Option | Yes |
| Energy Star Certified | No |
| Weight | 120 lbs |
| Drying Cycles | Delicates, Timed Dry, Air Fluff, More Dry, Less Dry, Normal |
| Model | MDE/MDG21PDA |
Emphasizes understanding safety symbols and labels before servicing.
Detailed steps and warnings for proper grounding of electrical equipment.
Explains the interrelationship of sensor, igniter, and gas valve in the ignition and heat source operation.
Describes fail-safe operation features for power interruptions, ignition, and flame failures.
Lists essential electrical testing equipment required for Maytag product servicing.
Guidance on diagnosing electrical circuit malfunctions by understanding normal operation.
Procedure for checking the centrifugal switch for proper operation.
Explains the use of manometers for checking gas pressure and diagnosing flow issues.
Covers common mechanical issues like the dryer not running, shutting off, or drying properly.
Flowchart for diagnosing a dryer that will not heat.
Steps to initiate and run the single dryer diagnostic program.
Details diagnostic codes d9, d12, and d16 related to voltage, motor sensing, and card readers.
Troubleshooting for operator options, display flashes, program selection, and drum not turning in stack dryers.
Steps to initiate and run the diagnostic program for stack dryers.
Details diagnostic codes d9, d12, d14, and d16 for stack dryer voltage, motor sensing, and card readers.
Steps for checking the drive motor's continuity and resistance.
Method for testing the drive motor's operational status using test leads.
Steps for removing the cycling thermostat.
Detailed instructions for removing the blower wheel and blower assembly components.
Instructions for removing the gas valve assembly.
Instructions for removing the low-cycling thermostat.
Instructions for removing the complete drive motor assembly.
Procedure for removing the thermal fuse.
Procedure for removing the motor switch from the drive motor.
Instructions for entering and using the dryer diagnostic mode for single and stacked models.
