Tools needed for installation
• Teflon tape or pipe
joint compound (gas only)
• Cutting knife
• Pipe wrench (gas only)
• Nut drivers
" Level
• Screw driver (standard)
• Duct tape
• Crescent wrench
ITEMS PROVIDED
0O
O0
Electric Dryer
Only
Gas Dryer
Only
Proper installation is the responsibility of the owner.
HOWEVER, SERVICE CALLS PERFOR_,4ED AS A RESULT OF POOR SET=UP, ADJUSTMENT AND
CONNECTION ARE THE RESPONSlBlUTY OF THE INSTALLER.
Make sure you have everything necessary for proper installation.
1. GROUNDED ELECTRICAL OUTLET is required. See Electric Requirements.
2. POWER CORD for electric dryers (except Canada).
3. GAS LINES (if a gas dryer) must meet National and Local Codes.
4. EXHAUST SYSTEM - must be rigid metal or flexible stiff walled metal exhaust ducting. See Exhaust Requirements.
CABINET DIMENSIONS
9700 series
A. Height-overall
B. Width
C. Depth-With Dryer Door Open 90°
D. Depth
E. Bottom Vent Hole Location - From Back
_]_)Center of Hole
Side Vent Hole - From Back '1_ Center Of
Hole
C _
38" (96.5)
27" (68.6)
49-3/8" (125.4)
30-3/8" (77.2)
7-1/2" (19)
S-1/2" (21.6)
A
6700 series
A. Height-overall
B. Width
C. Depth-With Dryer Door Open 90°
D. Depth
E. Bottom Vent Hole Location - From Back
_]_)Center of Hole
Side Vent Hole - From Back To Center Of
Hole
38" (96.5)
27" (68.6)
46-7/t6" (123.0)
28" (71.0)
7-1/2" (19)
8-1/2" (21.6)
Note:
The height of the dryer from top to floor is 38" with the leveling leg screwed all the way in, The customer can
unscrew the leg out an additional 7\8" for a total overall height of 38 7/8",
To Next Page
Loading...
