10 PROGRAMMING MANUAL 516532 B PUBLICATION DATE 1 JUN 2007.DOC
T Programming Extraction speed
- Speed Limits
Check table 3.4.B for the minimum and maximum speed limits. The limits differ depending on the
maximum allowed g-force at high spin for each washing machine size.
T Programming Supplies
1 Soap Supply Signal can be programmed for each of the following: prewash, wash and final rinse.
If Liquid soap pumps have been installed on the washing machine, then a pulse signal has to be sent
to the external control system to activate the pumps. The pulse time value has to be programmed in
the Soap Supplies menu-item.
Default time is set for zero seconds.
- Time Limits
The maximum programmable time is 99 Seconds
If the time is 0 Seconds then the supply will NOT be activated during the wash cycle.
T Programming the Sequence time.
The sequence time starts running after the programmed water level has been reached.
- Time Limits
DEPENDS OF SEQUENCE TYPE. SEE INFO IN TABLES - 6 STANDARD WASH CYCLES.
To Next Page
Loading...
