Need help?Do you have a question about the Maytag MFS35 and is the answer not in the manual?
Important safety instructions and precautions for operating the machine, including electrical and environmental considerations.
Explanation of symbols and button functions in Run Mode and Service – Set-Up Mode.
Overview of the control system's features, language options, and payment modes.
How to access and navigate the service and set-up menus for machine configuration.
Details on how wash programs are built with sequences and programmable functions.
Explanation of programming limits, water temperature, and water level settings.
Settings for coin and card reader, cycle prices, and money counter management.
Configuration for time-based and temperature-based special pricing.
Setting language, water temperature, and fill time parameters for the machine.
Setting machine type, display brightness, and inverter parameters.
How to access and edit individual steps within wash programs.
Steps for starting up, loading laundry, and adding detergent or softener.
How to advance, stop, and monitor the active wash cycle's progress.
Procedures for failure messages, power interruptions, and cycle status.
Explanation of water inlet valves, water levels, and tub actions (RPM).
Step-by-step parameters for Whites, Color, Bright Colors, Permanent Press, Quick Wash, and Delicates cycles.
Overview of display messages, fault codes, and diagnostic messages.
Procedures for managing and resolving fault messages and safety conditions.
Steps for running diagnostic tests, interpreting results, and checking common problems.
Accessing service menus for cycle credits, fault logs, and statistics.
Instructions for cleaning buttons and general machine care.
Information about the circuit board components, connections, and specifications.
Step-by-step guide for replacing the electronic board assembly.
Procedure for updating the machine's software via flash memory.
Key data points like type, serial number, voltage, and water supply.
Details on the programmer type, serial number, and software versions.
Recorded settings for machine type, display, language, and temperature.
To Next Page
General
