Maytag MVWC200XW Energy Guide

Maytag MVWC200XW

2 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

$10 $71

$

50

▼

•

Cost range based only on standard capacity models.

•

Estimated operating cost based on eight wash loads a week and a 2007

national average electricity cost of 10.65 cents per kWh and natural gas

cost of $1.218 per therm.

•

For more information, visit www.ftc.gov/appliances. (P/N W10062949)

U.S. Government Federal law prohibits removal of this label before consumer purchase.

Cost Range of Similar Models

Clothes Washer

Capacity: Standard

Maytag

Model: MVWC200X*

Cat. V0Xq8EUA(3B)

Estimated Yearly Operating Cost

(when used with an electric water heater)

470kWh

Estimated Yearly Electricity Use

Your cost will depend on your utility rates and use.

$29

Estimated Yearly Operating Cost

(when used with a natural gas water heater)

Other manuals for Maytag MVWC200XW

Use And Care Guide36 pages

Questions and Answers:

N
Nina VargasAug 17, 2025
What to do if my Maytag MVWC200XW won’t start or fill with water?
- A
  Ariana GarciaAug 18, 2025
  To get your Maytag Washer running, first ensure the power cord is plugged into a grounded 3-prong outlet and that you're not using an extension cord. Verify that the outlet has power. Check the circuit breaker and replace any blown fuses. Remember, the lid must be closed for the washer to operate. Also, the washer will pause during certain cycles, so avoid interrupting it. If the problem persists, it is recommended to contact an electrician.
S
Stephen RossAug 20, 2025
Why is my Maytag MVWC200XW not draining or spinning properly?
- D
  Donna LoganAug 20, 2025
  If your Maytag Washer isn't draining or spinning, and your loads are still wet, try the following: First, select the Drain & Spin cycle to remove extra water if small items are caught in the pump or between the basket and tub. Ensure the load is evenly arranged to allow for balanced spinning. Also, check the drain hose to make sure it's properly installed, not taped over, and not clogged. Finally, always measure detergent correctly to avoid excess suds, and if needed, select Rinse & Spin without adding detergent to remove extra suds.
W
wellsericAug 22, 2025
What to do if my Maytag MVWC200XW Washer load is not rinsing correctly?
- J
  jonathanmedinaAug 22, 2025
  If your Maytag Washer load is not rinsed properly, check that the hot and cold inlet hoses are connected correctly and that both faucets are turned on. Also, inspect the inlet valve screens for clogs and remove any kinks in the inlet hose. Ensure you're using the correct amount of detergent, as too much can prevent proper rinsing. Load garments loosely around the basket wall, using a cycle designed for the fabrics being washed, and avoid adding more than 1 or 2 extra items after the cycle has started.
D
Douglas RomeroAug 26, 2025
How to prevent fabric damage when using my Maytag MVWC200XW?
- M
  Michael Moran Jr.Aug 26, 2025
  To prevent fabric damage in your Maytag Washer, empty pockets, zip zippers, and fasten hooks before washing. Tie all strings and straps to prevent tangling. Mend any rips in seams before washing. Load garments loosely and use the correct cycle for the fabric type. Avoid adding too many items after the cycle has started, and never pour liquid chlorine bleach directly onto the load. Always follow garment care instructions and avoid overusing bleach.
C
Charlene GouldAug 27, 2025
Why is my Maytag MVWC200XW Washer not cleaning or removing stains effectively?
- G
  gloriahammondAug 28, 2025
  If your Maytag Washer isn't cleaning or removing stains effectively, ensure the load is not tightly packed, and load garments loosely around the basket wall. Add detergent, oxi products, and color-safe bleach to the bottom of the basket before adding clothes. Use a higher soil level cycle and warmer water temperature. For tough cleaning, use the Heavy Duty-Heavy cycle. Use dispensers to avoid staining from chlorine bleach and fabric softener, and do not add products directly onto the load.
J
John RamirezAug 30, 2025
How to prevent clothes from tangling in my Maytag MVWC200XW?
- R
  Ronnie HoffmanAug 30, 2025
  If your Maytag Washer is tangling clothes, load garments in loose heaps evenly around the basket wall. Select a cycle with a slower wash action and spin speed. Reduce tangling by mixing types of load items, and use the recommended cycle for the garments being washed.
A
Amber WashingtonSep 1, 2025
Why are the wash and rinse temperatures wrong on my Maytag Washer?
- D
  dorseynathanSep 2, 2025
  If the wash or rinse temperatures are incorrect on your Maytag Washer, check that the hot and cold inlet hoses are not reversed and that both hoses are attached with water flowing to the inlet valve. Ensure that inlet valve screens are not clogged and that there are no kinks in the hoses. Note that this washer uses cooler wash and rinse water temperatures than older models, including cooler hot and warm washes, to save energy.
S
Shane MoonSep 4, 2025
How do I get rid of odors in my Maytag Washer?
- N
  nicholas92Sep 4, 2025
  To address odors in your Maytag Washer, make sure to unload the washer as soon as the cycle is complete. Be sure to measure detergent correctly and always follow the manufacturer’s directions. Also, refer to the “Cleaning Your Washer” section.
S
sanchezwilliamSep 7, 2025
Why is there still sand or pet hair on my clothes after washing in my Maytag Washer?
- R
  Rebecca MitchellSep 7, 2025
  If you find sand, pet hair, or lint on your clothes after washing in your Maytag Washer, it may require additional rinsing because of heavy sand, pet hair, lint, and detergent or bleach residues. Try adding an Extra Rinse to the selected cycle.
C
cobbnicoleSep 9, 2025
Why is the lid locked light flashing on my Maytag MVWC200XW Washer?
- J
  Joanna DavenportSep 9, 2025
  If the lid locked light is flashing on your Maytag Washer, ensure that the lid is fully closed, as the washer won't start or fill if the lid is open. If a cycle was stopped or paused, the lid will not unlock until the basket has stopped spinning, which may take several minutes, especially with large loads or heavy fabrics.

Maytag MVWC200XW Specifications

General

Brand	Maytag
Model Number	MVWC200XW
Product Type	Top Load Washer
Color	White
Capacity	3.6 cu. ft.
Agitator	Yes
Energy Star Certified	No
Voltage	120V
Spin Speed	700 RPM
Configuration	Top Load
Width	27.5 inches
Depth	27 inches
Water Level Selection	Automatic
Height	43 inches

Related product manuals

Preview: Maytag MVWC200

Preview: Maytag MVWC200BW

Maytag MVWC200BW

Maytag MVWC200BW1

Preview: Maytag MVWC565FW

Maytag MVWC565FW

Maytag MVWC360AW

Preview: Maytag MVWC415EW

Maytag MVWC415EW

Maytag MVWC300XW

Maytag MVWC555DW

Preview: Maytag MVWC565FW2

Maytag MVWC565FW2

Maytag MVWC300BW1

MVWC700VJ - Centennial Washer

Preview: MVWC300VW - Centennial Washer

MVWC300VW - Centennial Washer