10
Removing the Fabric Softener Dispenser
1. Grasp the corner lip of the fabric softener dispenser.
Lift the dispenser up and tip it to the left to avoid hit-
ting the washer frame. (Illustration #1)
2. Under the fabric softener dispenser in the dispensing
compartment is an overflow grate. Grasp the overflow
grate by the word “CAUTION” and pull it up and out
of the dispensing compartment. (Illustration #2)
3. Take the fabric softener dispenser and the overflow
grate to the sink. Be careful, there may be fabric soft-
ener left in the dispenser. Lift the light blue siphon cap
out of the fabric softener dispenser. (Illustration #3)
4. Run warm water over the dispenser, light blue siphon
cap and overflow grate to remove any build-up. A soft
cloth may be used for stubborn stains.
Replacing the Fabric Softener Dispenser
1. Grasp the overflow grate so the word “CAUTION”
can be read. Place it in the dispensing compartment as
shown in illustration #4.
2. Place the light blue siphon cap over the stand pipe in
the fabric softener dispenser. It should fall into place.
(Illustration #5)
3. Grasp the corner lip of the fabric softener dispenser.
Tilt it slightly to the left and insert it back into the dis-
penser compartment. (Illustration #6)
#1 #2 #3
#4 #5 #6
Maytag does not recommend placing the plastic dispenser parts in the dishwasher.
If laundry additives were on the parts when washed in the dishwasher,
they may cause oversudsing in the dishwasher.
Cleaning the Dispensers (Cont.)
To Next Page
Loading...
Need help?
General