19
Won’t Fill
Won’t Spin
or Drain
Door Locked
Shut; Will
Not Open
Won’t Tumble
Check these points if your clothes washer...
Before You Call
• Be sure the door is tightly closed.
• ON light should be lit.
• Plug cord into a live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control dial to the proper cycle and push the START/STOP button.
Be sure the buttons are fully depressed.
• Turn both faucets on fully.
• Straighten inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Open and close the door, then push the START/STOP button.
• Low water pressure.
• Check fuse or reset circuit breaker.
• Turn the control dial to proper cycle and push the START/STOP button.
Be sure the buttons are fully depressed.
• Close the door and push the START/STOPbutton. For your safety, the clothes wash-
er will not tumble or spin unless the door is closed.
• ON light should be lit.
• Check fuse or reset circuit breaker.
• Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction, call for
service.
• Close the door and push the START/STOP button. For your safety, washer will not
tumble or spin unless the door is closed.
• After pressing the START/STOP button, it may take a few moments before the
clothes washer begins to spin. The door must lock before spin can be achieved.
• Press the START/STOP button to stop the washer.
• It may take 1 1/2 to 2 minutes for the door lock mechanism to disengage.
• Pull on the door indentation opposite the hinges.
For problem laundry solutions (i.e. fabric damage, residue, tangling) and special laundry care
procedures, see the enclosed Laundering Tips pamphlet.
(Continued on next page.)