5
OPERATING INSTRUCTIONS
Step 5
Press the arrow pad to select the spin speed.
Max Extract – Use for heavy loads such as towels and bedding.
Removes more water from loads during spin.
High/Flat Dry – Use for underwear, t-shirts and sturdy cottons or for
items that will be laid flat to dry.
Medium – Use for jeans, wrinkle free or “wash-and-wear” items and
synthetics.
Low/Hang Dry – Use for delicate items needing a slow spin speed
because of fabric and construction and for hang-dry items.
SELECT SPIN
FABRICS NOTE: To minimize wrinkling of wrinkle free and no-iron
fabrics, do not use the Max Extract spin option for these loads. Also, DO
NOT overload the washer.
Step 6
Press the appropriate pad(s) to select one or more options.
Set Delay Time – Allows the start of any cycle to be delayed for up to
9 hours. Make the appropriate selections for your load, then press the
up or down arrows to increase or decrease the delay time from one to
nine hours. Press the Start/Pause pad to start the delay time count-
down.To cancel a delay, press Off and reselect the cycle.
Presoak – Adds 12 minutes of mostly soaking with minimal tumbling
before the cycle. Can be selected with any cycle.
Extra Rinse – Adds an additional rinse at the end of the cycle to more
thoroughly remove laundry additives and perfumes.
Signal – Press the signal pad to increase or decrease the end of cycle
signal volume.
SELECT CYCLE OPTIONS
To Next Page
Loading...
