Black plate (279,1)
Fog light bulbs
í
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. Turn the screw counterclockwise and
remove it, and then partially peel back
the mudguard.
3. Disconnect the electrical connector
from the bulb by pressing the tab on
the connector with your finger and
pulling the connector.
4. Turn the bulb assembly
counterclockwise and remove it.
5. Install the ne w bulb in the reverse order
of the removal procedure.
NOTE
l
To replace the bulb, contact an Authorized
Mazda Dealer.
l
If the halogen bulb is accidentally touched,
it should be cleaned with rubbing alcohol
before being used.
l
Use the protective cover and carton of the
replacement bulb to dispose of the old bulb
promptly out of the reach of children.
Front turn signal light s
1. Make sure the ignition is switched off,
and the turn signal switch is off.
2. Lift the hood.
3. Turn the socket and bulb assembly
counterclockwise and remove it.
Maintenance and Care
Owner Maintenance
8-35
í
Some models.
Mazda2_8DB3-EC-13G_Edition4 Page279
Wednesday, June 4 2014 10:32 AM
Form No.8DB3-EC-13G
To Next Page
Loading...
