5-37
Driving Your Mazda
Switches and Controls
Form No. 8Q36-EA-01F
The ignition switch must be in the ON
position.
▼
Rear Window Wiper
Turn the wiper on by turning the knob.
ON
—
Normal
INT
—
Intermittent
▼
Rear Window Washer
To spray washer fluid, turn the knob to the
position. After the knob is released,
the washer will stop.
If the washer doesn’t work, inspect the
fluid level (page 8-20). If it’s OK and the
washer still doesn’t work, consult an
Authorized Mazda Dealer.
The rear defroster clears frost, fog, and
thin ice from the rear window.
The ignition switch must be in the ON
position.
Push the switch to turn on the rear
window defroster; the indicator light will
come on.
Push the switch again to turn it off.
Rear Window Wiper and
Washer (Hatchback)
NOTE
There are two washer positions: up and
down. In the down washer position, the
wiper will not be activated.
Washer
Washer
ON
INT
OFF
Rear Window Defroster
Don’t use sharp instruments or
window cleaners with abrasives to
clean the inside of the rear window
surface. They may damage the
defroster grid inside the window.
NOTE
This defroster is not designed for
melting snow. If there is an
accumulation of snow on the rear
window, brush it off before using the
defroster.
To Next Page
Loading...
