3
–
6
Before Driving
Keys
N O T E
y
The system can be set to unlock all
doors by performing a single operation.
Refer to Personalization Features on
page 9-12 .
Use the following procedure to change
the setting.
1. Switch the ignition off and close all
of the doors and the liftgate/trunk
lid.
2. Open the driver's door.
3. Within 30 seconds of opening the
driver's door, press and hold the
UNLOCK button on the key for 5
seconds or longer. The sound of
the doors locking/unlocking can be
heard.
After this, the system switches the
setting each time the UNLOCK
button is pressed (the sound of the
doors locking/unlocking can be
heard).
4. The setting change is completed by
doing any one of the following:
y
Switching the ignition to ACC or
ON.
y
Closing the driver's door.
y
Opening the liftgate/trunk lid.
y
Not operating the key for 10
seconds.
y
Pressing any button except the
UNLOCK button on the key.
y
Pressing a request switch.
y
(Auto re-lock function)
After unlocking with the key, all
doors and the liftgate/trunk lid will
automatically lock if any of the
following operations are not performed
within about 60 seconds. If your
vehicle has a theft-deterrent system,
the hazard warning lights will À ash for
con¿ rmation.
The time required for the doors to lock
automatically can be changed.
Refer to Personalization Features on
page 9-12 .
y
A door or the liftgate/trunk lid is
opened.
y
The ignition is switched to any
position other than off.
y
(With theft-deterrent system)
When the doors are unlocked by
pressing the unlock button on the key
while the theft-deterrent system is
turned off, the hazard warning lights
will À ash twice to indicate that the
system is turned off.
Trunk button (4–door)
To open the trunk lid, press and hold the
trunk button until the trunk lid opens.
Mazda38FA4-EA-15GEdition3.indb6Mazda38FA4-EA-15GEdition3.indb6 2015/12/0419:12:092015/12/0419:12:09
To Next Page
Loading...
