Continue to press and hold the HomeLink
button while you press and release ―
every two seconds (“cycle”) your hand-
held transmitter until the frequency signal
has successfully been accept ed by
HomeLink. (The indicator light will flash
slowly and then rapidly.)
Proceed with “Programming” step 4 to
complete.
qOperating the HomeLink System
Press the programmed HomeLink button
to operate a programmed device. The
code will continue being transmitted for a
maximum of 20 seconds.
qReprogramming the HomeLink
system
To program a device to HomeLink using a
HomeLink button previously trained,
follow these step s:
1. Press and hold the desired HomeLink
button. DO NOT release the button.
2. The indicator light will begin to flash
after 20 seconds. Without releasing the
HomeLink button, proceed with
“Programming” - step 2.
qErasing Programmed HomeLink
Buttons
To erase the existing programming from
all three operating channels, press and
hold the two outside buttons (
, )
on the auto-dimming mirror until the
HomeLink indicator light begins to flash
after approximately 20 seconds.
Verify that the programming has been
erased when you resell the vehicle.
5-76
Driving Your Mazda
Switches and Controls
Mazda6_8BG7-EC-10H_Edition1 Page224
Monday, August 2 2010 1:27 PM
Form No.8BG7-EC-10H
To Next Page
Loading...
