14. Prompt: “XXXXXX - - - (Ex.
“Stan's device”) (Device tag). Is this
correct?”
15. Say: [Beep] “Yes”
16. Prompt: “Pairing complete”
After a device is registered, the system
automatically identifies the device. By
activating Bluetooth Hands-Free again, or
by activating Bluetooth Hands-Free first
after switching the ignition from OFF to
ACC, the system reads out a voice
guidance, “XXXXXX - - - (Ex. “Stan's
device”) (Device tag) is connected”.
NOTE
l
Device registration can also be done by
operating the audio unit or panel buttons
on the navigation unit.
l
(Type A)
Refer to “Bluetooth Audio Preparation”
(page 6-80).
l
(Type B)
Refer to “Bluetooth Audio Preparation”
(page 6-90).
l
(Navigation system)
Refer to the separate manual
“NAVIGATION SYSTEM Owner's
Manual”
l
Depending on the device, the registration
status may be lost after a certain period of
time. If this occurs, repeat the entire
process from Step 1.
qMaking a Call Using a Telephone
Number
NOTE
Practice this while parked until you are
confident you can do it while driving in a non-
taxing road situation. If you are not completely
comfortable, make all calls from a safe
parking position, and move out only when fully
under control and you can devote your eyes
and mind to driving.
1. Press the pick-up button (with/without
navigation system) or talk button with
a short press (without navigation
system) or a long press (with
navigation system).
NOTE
For vehicles with the navigation system, you
can also press the talk button with a short
press and say: [Beep] “Telephone” or
“Phone”.
2. Say: [Beep] “Dial”
3. Prompt: “Number, plea se”
4. Say: [Beep] “XXXXXXXXXXX
(Telephone number)”
5. Prompt: “XXXXXXXXXXX.
(Telephone number) After the beep,
continue to add numbers, or say Go-
Back to re-enter the last entered
numbers, or press the Pick-Up button
to execute dialing.”
6-104
Interior Comfort
Bluetooth Hands-Free (Voice Recognition)
Mazda6_8BG7-EC-10H_Edition1 Page328
Monday, August 2 2010 1:28 PM
Form No.8BG7-EC-10H
To Next Page
Loading...
