Mazda 6 - Dtc P0106

F2–60
ON-BOARD DIAGNOSTIC
DTC P0106
B6E407000100104
DTC P0106 Boost sensor range/performance problem
DETECTION
CONDITION
• The PCM monitors the vacuum inside the intake manifold. If the difference of the vacuum inside the intake
manifold during middle engine speed and low engine speed is less than the threshold, the PCM determines
that there is a malfunction in the manifold absolute pressure sensor characteristic.
Diagnostic support note
• The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or
in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
• PENDING CODE is available if the PCM detects the above malfunction condition.
• FREEZE FRAME DATA is available.
• The DTC is stored in the PCM memory.
POSSIBLE
CAUSE
• Boost sensor malfunction
• Connector or terminal malfunction
• PCM malfunction
90
36
91
C
B
A
4
4
4
5
6
6
6
BOOST SENSOR
PCM
BOOST SENSOR
WIRING HARNESS-SIDE
CONNECTOR
PCM
WIRING HARNESS-SIDE
CONNECTOR
ABC
1234567891011121314151617181920212223242526
27282930
53
54
555657
58
5960
798081828384858687888990
31323334
35
36
37383940
61
62
6364
6566
6768
6970
919294 939596979899100
41
4243
44
4546
47
484950
71
7273
74
7576
7778
51
52
101102103104