Mazda BT-50 2017 - Interior Lamps; Changing a Bulb

Black plate (67,1)
INTERIOR LAMPS
qCourtesy lamp
A Off
B Door contact
COn
If you set the switch to position B, the
courtesy lamp will come on when you
unlock or open a door. If you leave a door
open with the ignition switch off, the
courtesy lamp will go off automatically
after some time to prevent the vehicle
battery from discharging. To switch it
back on, switch on the ignition for a short
time.
The courtesy lamp will also come on
when you switch off the ignition. It will
go off automatically after a short time or
when you start or restart the engine.
If you set the switch to position C with
the ignition switch off, the courtesy lamp
will come on. It will go off automatically
after a short time to prevent the vehicle
battery from discharging. To switch it
back on, switch on the ignition for a short
time.
CHANGING A BULB
WARNING
l
Switch the lights and the ignition
off.
l
Let the engine compartment and
the bulb cool down before removing
it.
CAUTION
Only fit bulbs of the correct
specification. See Bulb Specification
Chart (page 66).
NOTE
The foll owing instructions describe
how to remove the bulbs. Fit
replacements in the reverse order unless
otherwise stated.
You may notice fogging or small water
droplets in the lamp units from time to
time. This does not affect the function of
the lamp, and will clear when the lamps
are turned on and the vehicle is driven.
NOTE
If in any doubt about any of the
following bulb replacement procedures,
please have the bulb replaced by your
Authorised Mazda Repairer.
Lighting
59
Mazda BT-50_8FX5-EI-17DT_Edition2 Page67
Thursday, May 11 2017 5:31 PM
Form No.8FX5-EI-17DT