7
–
10
If Trouble Arises
Flat Tyre
6. Shake the sealant bottle to mix the
contents. Then extend the injection
hose.
Injection hose
CAUTION
Do not shake the bottle excessively.
Otherwise, the sealant could spray out
of the injection hose, and if the sealant
contacts clothing or other objects, you
may not be able to remove it.
NOTE
The sealant hardens easily and injecting
it will be diffi cult under cold weather
conditions (0 °C (32 °F) or below).
Warm the sealant inside the vehicle to
facilitate injection.
7. Pull out the compressor hose and
the compressor plug from the air
compressor.
Compressor hose
8. Install the compressor hose which was
pulled out of the air compressor to the
injection valve of the bottle.
Compressor hose
Injection hose
Injection
valve
CAUTION
Make sure that the air compressor
switch is OFF before inserting the
compressor hose to the injection valve
of the bottle. If the compressor hose is
not installed to the injection valve of the
bottle securely, the sealant may leak.
To Next Page