7
–
11
If Trouble Arises
Flat Tyre
9. Remove the valve cap from the valve
of the fl at tyre, install the injection hose
to the tyre valve, turn the sleeve to the
right, and tighten it.
Valve cap
Valve
Injection hose
10. Install the bottle to the air compressor
and press it in until the left and right
tabs are engaged securely.
Tabs
11. Insert the air compressor plug into the
accessory socket inside the vehicle and
switch the ignition to ACC.
Refer to Accessory Sockets on page
5-155 .
Centre console
Compressor
Compressor plug
CAUTION
When inserting the air compressor
plug into or removing it from the
accessory socket, make sure that the air
compressor switch is OFF. When turning
the air compressor ON/OFF, use the air
compressor switch.
12. The sealant is injected into the tyre
when the air compressor is switched
ON. After the sealant is injected
completely, wait until the tyre infl ation
pressure increases to the specifi ed tyre
infl ation pressure.
NOTE
The infl ation pressure may increase
to about 300 kPa (3.1 kgf/cm
2
, 3 bar,
43.5 psi) temporarily to inject the
sealant through the valve. Normally, the
infl ation pressure decreases gradually
and it reaches the actual infl ation
pressure after about 30 seconds.
To Next Page