x
Display of the top view/front view, top view/front wide view, or the side view
stops even with the display conditions met if any of the following conditions
occurs.
x
When a switch around the commander knob is pressed.
x
The selector lever is shifted to P position (displayed when the selector lever is in
a position other than P).
x
(Displayed when vehicle speed is less than 15 km/h (9.3 mph))
x
4 minutes and 30 seconds have passed.
x
The vehicle speed is about 15 km/h (9.3 mph) or faster.
x
(Displayed when the vehicle speed is about 15 km/h (9.3 mph) or faster)
x
The vehicle speed is about 15 km/h (9.3 mph) or faster after 8 seconds have
passed since pressing the 360°View Monitor switch.
x
4 minutes and 22 seconds have passed from the point when the vehicle speed
was less than 15 km/h (9.3 mph) after 8 seconds have passed since pressing
the 360°View Monitor switch.
x
The 360°View Monitor settings can be changed as follows.
Refer to the Settings section in the Mazda Connect Owner's Manual.
x
Automatic display of the 360°View Monitor when the ultrasonic sensor detects
an obstruction.
x
Automatic display of the 360°View Monitor when the power switch is switched
ON.
x
Screen priority level when the system launches.
Top view/Rear view, Top view/Rear wide view
The top view/rear view, top view/rear wide view displays when all of the following
conditions are met.
x
The power switch is switched ON.
x
Selector lever is in R position.
Display switching
The displayed screen can be changed each time the 360°view monitor switch is
pressed.
1. Top view/Rear view
2. Top view/Rear wide view
When Driving
i-ACTIVSENSE
4-167
To Next Page
Loading...
