Black plate (371,1)
7. Remove the adapter.
8. Install the new bulb in the reverse order
of the removal procedure.
Fog light bulbs
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. Turn the screws and the center section
of the plastic retainers
counterclockwise and remove them,
then partially peel back the mudguard.
Removal
Installation
3. Disconnect the connector from the bulb
by pressing the tab on the connector
with your finger and pulling the
connector downward.
4. Turn the socket and bulb assembly to
remove it. Carefully remove the bulb
from its socket in the reflector by
gently pulling it straight backward out
of the socket.
5. Install the new bulb in the reverse order
of the removal procedure.
Front side-marker lights
1. Make sure the ignition is switched off,
and the headlight switch is off.
Maintenance and Care
Owner Maintenance
8-41
MX-5_8DG7-EC-13F_Edition2 Page371
Tuesday, September 24 2013 10:13 AM
Form No.8DG7-EC-13F
To Next Page
Loading...
