5
ENGLISH
7) INSTALLATION AND WIRING
The appliance must be installed by skilled technical personnel in conformity with
the safety rules in force. Incorrect installation may result in injury of persons or
animals, or damage to property, for which the manufacturer cannot be held
responsible.
•
The appliance must be placed on a stable,flat surface.
•
Before plugging in the appliance, make sure the voltage and frequency values of
the supply mains correspond to the ratings indicated on the label featuring the
appliance’s technical data.
•
The wall socket must be fitted with an efficient earth contact.Consequently, it
is essential to make sure the earth system is efficient and in conformity with
current safety rules.If in any doubt,have the system thoroughly checked by per-
sonnel with the appropriate professional skills.
IT IS COMPULSORYTO EARTH THE APPLIANCE.
The manufacturer cannot be held responsible in the event this regulation is not
complied with.
•
It is essential to make sure the ratings of the system are suitable for the power
absorbed by the appliance - as indicated on the label featuring the technical data
- and that the wall socket is protected against overcurrents.
•
Do not use extension cables, plug adapters for multiple sockets or makeshift
connections.
•
In EEC member countries,the regulation in force calls for the external equipoten-
tial terminal on the outer part of the appliance’s base plate to be connected
to a equipotential node if the installation is to be correct.
•
The motor must rotate clockwise. If the rotation of three-phase motors
is to be inverted, by inverting the two power supply wires inside the plug,this
must be carried out by skilled personnel.
•
THE HOPPER MUST BE FASTENED TO THE APPLIANCE’S GRINDING
SYSTEM BY MEANS OF THE RELEVANT SCREW which must be inserted in
the threaded hole located on the upper grinding blade holder and in the hole
on the neck of the hopper.
inglese 23-07-2001 13:16 Page 5
To Next Page
Loading...
