EasyManua.ls Logo

MB TRAFx Generation 3 - F Lights, Batteries, Notes

Default Icon
9 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TRAFx MANUAL: PART II Mountain Bike Counter 2018 www.trafx.net
7
F LIGHTS, BATTERIES, NOTES
LIGHTS
The counter’s three small indicator lights are explained below.
Status Detection
State
S - Status LIGHT
(RED)
C - Calibration LIGHT
(ORANGE)
D - Detection LIGHT
(GREEN)
Sleeping*
2x per second
not active
2x per second
At Launch
4x per second
(rapid)
on = calibrating**
off = calibrated
not active
After START
1x per 4 seconds
not active
blink = count
Calibration * Sleeping means the counter is idling, waiting to be launched; it is not counting.
**If the Calibration LIGHT is permanently on see #5 on p. 9
BATTERIES
Battery Info
RATE-FAST
(Bat. life)
Three 1.5V alkaline C cells
cost approx. $1/each; widely sold (Costco, Home Depot, etc.)
use quality alkaline batteries (e.g., Energizer)
rechargeables (not recommended) last 40% to 70% less than alkaline batteries
in extremely cold climates (consistently below -20C / -2F) plan on 50% less battery life
battery failure risk increases above 55C / 131F
maximum total voltage: 5V
G4 counters
8 to 9 months
G2/G3 counters
7 to 8 months
! Caution --- Never mix batteries (brands, types, or age)
NOTES
Limitations: Two or more bikes in the detection zone at the same time may be counted as one.
After the counter begins recording data (i.e., after START is reached), counts are recorded if you
move the counter, or move ferrous metal objects (e.g., shovel) near it.
To better secure
the batteries,
particularly if
moving the counter,
use duct tape.
turn battery holder upside down
tape from side to side as shown
it is only necessary to tape the
two batteries shown