MBRAUN EasyLab - Page 30

Operating Manual
Operation instructions Page 3-7
3.3.4 Equipment for Regeneration Gas Connections
！
NOTE!
MBRAUN recommends the use of a special pressure reducing
valve fitted
with a non-standard secondary gauge that is
calibrated between
0 – 1.5 bar (0 – 0.15 MPa).
This is available from
MBRAUN – Part No. 2411006.
Pressure Reducing Valve for Regeneration Gas:
Use
Regeneration pressure control system.
Pressure,
200 bar (20 MPa) primary, 0.3-0.4 bar (30 – 40 kPa)
secondary,
Flow rate
flow rate of approximately 1.25 m³/h
Connection
Ø 9 mm hose or Ø 10 mm Swagelok fitting.
Type
Supply Piping for Regeneration Gas:
Use
Connecting the working gas source with the
Regeneration Gas
IN
system connection.
Material
Optional (length as required):
Either Ø 9 mm reinforced hose, 3 mm wall thickness and
adapter,
or Ø 10 mm copper pipe or Ø 10 mm stainless steel pipe
Connection
Ø 9 mm hose nozzle or Ø 10 mm Swagelok fitting.
Type