Why are the measurement values on the MBRAUN Laboratory Equipment analysers inaccurate?
If the MBRAUN Laboratory Equipment's analysers were exposed to air, they require time to provide accurate measurements. Specifically, the O2 analyser needs several hours, while the H2O analyser may need up to 24 hours.
What to do if regeneration cycle performance decreases in MBRAUN MB200MOD?
If the regeneration cycle performance of your MBRAUN Laboratory Equipment decreases significantly, or oxygen values remain high even after regeneration, perform a leak test.
Why is the O2 measurement value decreasing slowly in my MBRAUN Laboratory Equipment?
If the O2 measurement value decrease to below 10 ppm is very slow in your MBRAUN Laboratory Equipment, check the glovebox atmosphere for gas constituents like H2, which could cause increased indications. If the issue persists, return the O2 analyser to MBRAUN Service.
How to fix the start screen not appearing on MBRAUN Laboratory Equipment?
If the start screen doesn't appear after switching on your MBRAUN Laboratory Equipment, check the communication between the touch panel, Siemens PLC, and established link. Also, verify the connector and electrical supply. If the problem persists, contact MBRAUN Service.
General| Brand | MBRAUN |
|---|---|
| Model | MB200MOD |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
