INTRODUCTION
6 – English
Symbols on the machine:
WARNING! Chain saws can be
dangerous! Careless or incorrect use can
result in serious or fatal injury to the
operator or others.
Please read the operator’s manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
This product is in accordance with
applicable EC directives.
Noise emission to the environment
according to the European
Community’s Directive. The machine’s
emission is specified in the Technical
data chapter and on the label.
Both of the operator
′
s hands must be
used to operate the chain saw.
Never operate a chain saw holding it
with one hand only.
Contact of the guide bar tip with any
object must be avoided.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May
cause serious personal injury.
The engine is stopped by switching the
ignition off using the stop switch.
Chain brake, activated (front)
Chain brake, not activated (back)
Air purge
Refuelling.
Chain oil fill.
The rating plate
showing serial number.
yyyy
is the production
year,
ww
is the
productionweek and
xxxxx
is the sequential
number.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
yyyywwxxxxx
To Next Page
Loading...
Need help?
General