To Next PageTo Next Page
Need help?Do you have a question about the McCulloch M7053D and is the answer not in the manual?
General| Cutting Width | 53 cm |
|---|---|
| Engine Manufacturer | Briggs & Stratton |
| Engine Type | 4-stroke |
| Warranty | 2 years |
| Drive System | Self-propelled |
Read instructions, familiarize controls, prepare area, handle fuel safely, inspect components.
Mow safely, operate on slopes carefully, avoid wet grass, stop engine when leaving or refueling.
Ensure fasteners are tight, store safely, keep engine clean, replace worn parts.
Learn the meaning of symbols for safety, warnings, and operational guidance.
Identify symbols for hot surfaces, thrown objects, and danger zones for user safety.
CE marking and other symbols indicate compliance with European safety standards.
Identifies upper/lower handles, brake yoke, start handle, and clutch control lever.
Identifies air filter, petrol intake, and height adjustment grip for maintenance.
Steps to unfold and securely attach the mower handle using wing-nuts.
Instructions for fitting the rear foot guard essential for safe mower operation.
Steps to assemble frame, attach bindings, and secure catcher to mower housing.
Stop engine, lift rear door, remove catcher by handle, avoid dragging.
Instructions for switching between rear bagging, mulching, and discharging.
How to set desired cutting levels using the wheel lever for even cutting.
Procedure for checking engine oil level and filling if necessary.
Detailed steps for starting a cold or warm engine, including priming and brake yoke use.
How to shut off the engine by releasing the engine brake yoke.
How to activate and deactivate the mower's drive using the clutch control and brake yoke.
Guidelines for safe mowing on inclines, not exceeding 15 degrees.
Recommendations for mowing frequency and cutting no more than 1/3 of grass length.
Disconnect spark plug lead before any maintenance, cleaning, or repair work.
How to accurately check engine oil level with the dipstick after stopping the engine.
Procedure for annual grinding, balancing, and fitting of the cutter blade.
Steps for changing engine oil annually or after 25 hours of operation.
Instructions for removing the lid and cleaning the air filter cartridge.
Safety steps for transport, including spark plug lead removal and fuel tank emptying.
