McCulloch MC1230 - Troubleshooting

14
|
ENGLISH
Unit fails to heat up.
Steam output is weak or
intermittent.
Excessive amount of water in
steam.
NOTE: Unit produces wet steam
– it is normal for steam to
contain some amount of water.
Unit is not plugged in. Household
circuit breaker / ground fault inter-
rupter has tripped or blown a fuse.
Mineral build-up in unit.
Mineral build-up in unit.
Unit is damaged or otherwise in
need of repair.
Water level in Boiler is running
low.
Boiler is empty.
Water condensation in Extension
Hose.
Boiler has been
overlled.
Plug power cord into electrical outlet.
Refer to Mineral Build-up section
on Page 13 for cleaning procedure.
Refer to Mineral Build-up section
on Page 13 for cleaning procedure.
Reset circuit breaker / ground
fault interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Immediately cease usage and
unplug. Contact Consumer
Service for further assistance
(see Page 16 for details).
Refer to Filling The Boiler proce-
dure on Page 11.
Refer to Filling The Boiler proce-
dure on Page 11.
Point nozzle towards sink, tub or
ground and shake while pressing
Steam Trigger. Continue until
excess water is released.
Filling Boiler with more than 6 oz.
(177 ml.) of water interferes with
steam production, resulting in
water condensation in steam.
Always use included Fill Cup to ll
unit with correct amount of water.
(see Page 11 for details)
PROBLEM POSSIBLE CAUSE SOLUTION
Accessories do not stay rmly
connected to Steam Nozzle.
Accessories not properly installed. Check to make sure that acces-
sories are properly connected, per
procedures on Pages 8-9.
Troubleshooting