1. Open the top feed assemble by unscrewing the cover knob, and then remove the metal frame.
3. Close top feed, make sure knob fasten in proper position.
Note: The box must be locked rmly, otherwise the shredder cannot power on.
2. Since the blade is two side sharp for cutting, so could use both sides; Lock the blade disc
using screwdriver or similar tools. Remove the blade by Allen key and rotate it through 180
degrees then t the blade to the blade disc ensuring that the ground cutting edge is facing
downwards; Fix the metal frame back with screws.
Replace the Blade
Maintenance
1
2
Screwdriver
1
2
Allen key
Remove 2 hex headed screws
Rotate blade 180
o
Ensure that the shredder is switched off and disconnected from the mains supply. work
gloves be used when replacing the blades.
To Next Page
Loading...