27
Setup, con’t and Reset of the Microprocessors
In the unlikely event the controls of the MAC7200
stop functioning, the microprocessors can be reset by
performing the following:
1. Press the STANDBY/ON Push-button until the
STANDBY/ON LED Indicator switches Off.
2. Then release the STANDBY/ON Push-button and
the MAC7200 will switch Off.
3. When the STANDBY/ON LED is illuminated
press the STANDBY/ON Push-button, the
MAC7200 will resume normal operation.
Note: This can be performed with the MAC7200 On
or in the Standby Mode.
Reset of the MicroprocessorsFactory Reset
If it becomes desirable to reset all the adjustable set-
tings (Setup and Trim Settings) to the factory default
values, perform the following steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 17.
2. Rotate the INPUT Control until “FACTORY RE-
SET, (Hold INPUT)” appears on the Information
Display. Refer to figure 61.
3. Press and hold in the INPUT Control until “FAC-
TORY RESET, In Progress!” appears on the Infor-
mation Display, then release the INPUT Control.
Refer to figures 62 and 63.
4. Press the Front Panel STAND/BY Push-button to
switch On the MAC7200.
Figure 63
To Next Page
Loading...
