34
Remote Control. The third way is to use the Seek 7
or 8 Push-buttons on the Remote Control. Refer to
figure 70 and 108 on the previous pages.
Direct Access Tuning
The fourth Tuning way is to use the Direct Access
Method for FM and AM Stations. This is performed
by entering the Radio Station Frequency by using the
numeric Push-buttons on the Remote Control. Refer
to figure 108. For example, tuning to FM Station
105.7MHz press the following Push-buttons:
Number One, Number Zero, Number Five
and Number Seven.
Preset Tuning
The MAC7200 allows for presetting 20 AM and 20
FM Radio Stations into memory for rapid recall. Refer
to figure 108.
CREATE A PRESET
Perform the following steps:
1. Tune to the desired FM Station (or AM Station).
Refer to Figure 110.
2. Press the large PRESET Push-button (located
between the AM and FM Push-buttons) on the
Remote Control and the letter “P” will appear
flashing on the left side of the Front Panel Display.
Refer to Figure 111.
3. Using the Remote Control Numeric Push-buttons
enter the desired Preset Number. Refer to Figure
112.
4. Press the large PRESET Push-button to complete
the process of entering Preset One. The “P1” on the
Front Panel Information Display will stop flashing.
Refer to Figure 113.
ERASE A PRESET
Perform the following steps:
1. Use the Remote Control PRESET 9, PRESET :
Push-buttons or the Front Panel PRESET Control
to select the desired FM Station Preset (or AM Sta-
tion Preset) to be erased. Refer to Figure 113.
2. Press the large PRESET Push-button (located
between the AM and FM Push-buttons) on the
Remote Control, “P1” will disappear and the let-
ter “P” will appear flashing on the left side of the
Front Panel Display. Refer to Figure 111.
3. Press the large PRESET Push-button a second time
to complete the process of erasing Preset One.
The Front Panel Information Display will now just
indicate the Frequency, Mode and Signal Strength.
Refer to Figure 110.
Note: If it is desirable to remove all 20 Presets (FM
and/or AM Stations) refer to Setup “DELET-
ING PRESETS” on page 25
SELECTING A PRESET
There are several ways to scan thru available FM or
AM Preset Stations. Rotate the
Front Panel PRESET Control
Clockwise or Counterclockwise
to find the desired station. The
second way is to use the Remote
Control PRESET 9, PRESET
: Push-buttons. The third way
is using the Remote Control to
direct access the desired Preset
Number. First press the large
PRESET Push-button, then use
the numeric Push-buttons to
enter the Preset Number followed
by pressing the large PRESET
Push-button a second time.
Tuner Tex t
Select the TRIM Tuner Text
Mode using the Front Panel
Controls or Remote Control.
The defaut TRIM Tuner Mode
is “Station Info” which indicates
whatever a given Radio Station
wants to display. Refer to figure
106 on page 33. The second op-
tion is to display the RF Multipa-
th
1
Signal and Noise Background
of the tuned in FM Station or the
Signal Strength of the tuned in
AM Station. Refer to figure 107
on page 33. The third option is to
switch Off the second line of the
Front Panel Information Display.
1
Refer to “General Information” number
8 for addition information about RF
Multipath Signals.
Operating the FM and AM Tuner, con’t
Figure 108
Figu re 110
To Next Page
Loading...
