15
Figure 9
How to Operate the MCD1000
4. Press the PLAY Push-button to start playback of the
disc.
Note: Please wait until the MCD1000 has read and
displayed the number of Tracks and Total Playing
Time before pressing the PLAY Push-button. If the
PLAY Push-button is pressed before the number of
Tracks and Total Playing Time is displayed, there
will be about a nine second delay before the first
Track starts to play.
Unloading Compact Discs
The steps for removing the disc from the MCD1000 CD
Transport is similar to the Loading Disc Process, except in
reverse.
1. Press the Front Panel STOP Push-button if a Disc is
playing.
2. Press the OPEN/CLOSE Push-button and the Disc
Loading Tray will slide open to permit removal of the
Disc from the MCD1000 CD Transport.
Disc Playback
Press the PLAY Push-button and the disc will start play-
ing. The Front Panel Display will indicate the current Track
Number, the Time into the Track and a Triangle. When all
of the tracks on the disc have played the MCD1000 will
stop, unless the Repeat Playback Mode has been activated.
Refer to figure 6.
Direct Track Selection
To select a specific track on a Compact Disc perform the
following using a McIntosh Remote Control.
Figure 8
Figure 6
1. Press the NUMBER Push-button to select the desired
Track.
Note: If the desired Track Number is higher than 9, first
press and hold down the NUMBER Push-button until
the number entered shifts its position to the “Tens
Digit” followed by pressing the NUMBER Push-
button for the “Units Digit”. Refer to figure 7.
Disc Pause
While a Disc is playing, press the PAUSE Push-button to
temporarily stop playback. To cancel the Pause Mode, press
the PLAY Push-button or press the PAUSE Push-button
again and the disc will resume playing. The Front Panel
Display will indicate that the MCD1000 is in Pause Mode
with double vertical rectangles positioned to the right of the
Play Triangle. Refer to figure 9.
Stop Mode
Press the STOP Push-button at any time to stop Disc
Playback. If the MCD1000 is in Random, Intro and/or Pro-
gram Modes of Playback, pressing the STOP Push-button
will stop playing the disc and cancel the Random, Intro and/
or Program Modes of Playback. Refer to figure 8.
Back Track
Pressing the BACK Push-button while a Disc is play-
Figure 7
To Next Page
Loading...
Need help?
General
