McIntosh MCD350 User Manual

21
Resetting the MCD350
In the unlikely event the MCD350 stops functioning,
first try resetting the Main (System) microprocessor
by performing the following:
1. Simultaneously press and hold in the Front Panel
TIME and DISC LAYER Push-buttons until the
illumination of the LED above the STAND/BY
Push-button goes Off. The MCD350 will then
switch Off.
2. Press the STAND/BY Push-button to switch the
MCD350 back On.
If the MCD350 is still not functioning properly, reset
the Secondary (Transport) microprocessor by per-
forming the following:
1. Switch Off A.C. Power going to the MCD350.
Note: Temporarily, connect the AC Power
Cord coming from the MCD350 into an
AC Power Strip with an On/Off Switch.
Position the AC Power Strip so the On/Off
Switch on the strip is in very close proxim-
ity to the MCD350 Front Panel STOP Push-
button (the MCD350 Remote Control STOP
Push-button will not work for resetting the
microprocessor).
2. Press and Hold-In simultaneously the NEXT:
and STOP< Push-buttons and then switch On the
AC Power Strip.
3. The Front Panel will indicate “RESET” and then
go through the process of reading the Disc for
playback. At this time release the NEXT Push-
button and then the STOP< Push-button.
4. The MCD350 will resume normal operation.
How to Operate the MCD350, con’t

McIntosh MCD350 Specifications

General

Brand	McIntosh
Model	MCD350
Category	CD Player
Language	English