6
Installation
Installation
The MS500 can be placed upright on a table or
shelf, standing on its four feet. It also can be custom
installed in a piece of furniture or cabinet of your
choice. The four feet may be removed from the bottom
of the MS500 when it is custom installed as outlined
below. The four feet together with the mounting
screws should be retained for possible future use if the
MS500 is removed from the custom installation and
used free standing. The required panel cutout, ventila-
tion cutout and unit dimensions are shown.
Always provide adequate ventilation for your
MS500. Cool operation ensures the longest possible
operating life for any electronic instrument. Do not
install the MS500 directly above a heat generating
component such as a high powered amplifier. If all
the components are installed in a single cabinet, a
quiet running ventilation fan can be a definite asset in
maintaining all the system components at the coolest
possible operating temperature.
A custom cabinet installation should provide the
following minimum spacing dimensions for cool
operation.
Allow at least 3 inches (7.6cm) above the top, 2
inches (5.1cm) below the bottom and 1 inch (2.5cm)
on each side of the Music Streamer, so that airflow is
not obstructed. Allow 17 inches (43.2cm) depth behind
the front panel. Allow 29/32 of an inch (1.8cm) in
front of the front panel for clearance. Do not block the
openings on the top cover or the three rows of louvers
opening on the bottom of the MS500. Be sure to cut
out a ventilation hole in the mounting shelf according
to the dimensions in the drawing.
2-3/4"
7.0cm
17-1/8"
43.5cm
Cutout Opening for Custom Mounting
MS500 Front Panel
Custom Cabinet Cutout
Support
Shelf
Chassis
Spacers
MS500 Side View
in Custom Cabinet
MS500 Bottom View
in Custom Cabinet
14-17/32"
44.5cm
6-9/16"
16.7cm
2-27/32"
7.2cm
MS500 MUSIC STREAMER
Cabinet
Front
Panel
3"
7.6cm
Opening
for Ventilation
Note: Center the cutout Horizontally on the unit.
For purposes of clarity, the above
illustration is not drawn to scale.
2-19/32"
6.6cm
13/16"
2.0cm
Cutout Opening
for Ventilation
10-1/2"
26.7cm
11-7/8"
30.2cm
Cutout Opening for Ventilation
To Next Page
Loading...