Congratulations on your purchasing of a McLELLAND Mix-Lite USB Audio Interface.
Please take a few moments to read the entire manual, and be sure to retain this document for
future reference. Please read and observe all safety instructions detailed on each page.
INTRODUCTION
The McLELLAND Mix-Lite USB audio interface is designed as an audio interface between analog
and digital audio sources, recorders and a computer with USB 1.1 or 2.0 connection. It is suitable
for use on stage and in the sound recording studio as well as for home recording and multi-media
applications. Microphone signals, high-impedance instrument signals, analog line signals and
digital signals can be transmitted with superior sound quality to a computer where they can be
edited, mixed and published with corresponding production software. The audio interface is
compatible to PC and Mac and requires no setup thanks to its plug & play functionality.
The interface features two combo inputs for microphones and high-impedance music
instruments, an input for units with line level(e.g. CD players) as well as an input for digital audio
signals. For the analog inputs the amplification can be adjusted and for phantom-powered
microphones +48V phantom power can be switched on.
The audio signals coming from the computer and the preamplified analog input signals are
available at two 6.3mm jacks as well as at an adjustable 3.5mm headphones output. Additionally,
there is a digital output for the audio signals coming from the computer. The power supply for the
unit is made via the USB interface. Alternatively the supplied power unit or the 9V battery may be
used for an operation independent of the computer.
This product is allowed to be operated with 9V AC/DC, 150 mA and was designed for indoor use
only.
FEATURES
USB audio interface with integrated low-noise microphone preamplifiers
Plug & play audio interface connects microphones, instruments and line inputs with your
computer for recording and playback
Compatible with PC and Mac - no setup required
High-resolution AD/DA converters(16 bit/44.1 kHz and 48 kHz) for high-end audio quality
High-speed USB 2.0 support
2 microphone/line inputs(combination XLR/6.3mm jack, bal.), switchable
+48V phantom power can be switched on, status LED
Stereo RCA line input
Analog inputs with gain control and signal/clip LED
Digital S/PDIF input and output
Monitoring of input and output via adjustable stereo headphones output(3.5mm jack)
Balanced L/R 6.3mm jack stereo line output for PA applications
Power supply via USB, supplied 9V power unit or 9V block battery
The interface can also be used without a computer e.g. as an independent microphone
preamplifier for direct monitoring
Works with any customary software for PC and Mac
3
To Next Page
Loading...