How to restart McQuay M5WM015JR after power failure?
If your McQuay Air Conditioner doesn't automatically turn back on after a power outage, the auto-restart function may not be working. Try manually turning the unit on using the wireless or wired controller.
Why is my McQuay M5WM015JR not blowing warm air?
If your McQuay Air Conditioner isn't emitting warm air during the heating cycle, it might be in defrost mode. The heating operation should resume automatically once the defrost cycle is complete.
What to do if McQuay M5WM015JR Air Conditioner compressor doesn't start?
If the compressor in your McQuay Air Conditioner doesn't start immediately after turning the unit on, it might be due to a built-in protection against frequent starting. Wait 3 to 4 minutes; the compressor should start on its own.
Why does my McQuay Air Conditioner compressor run continuously?
If the compressor in your McQuay Air Conditioner is running constantly, it could be due to a dirty air filter. Try cleaning it. Alternatively, if you are cooling, the temperature setting might be too low; set it higher. If you are heating, the temperature setting might be too high; try setting a lower temperature.
Why is there condensation on my McQuay M5WM015JR?
Condensation on the front grille of your McQuay Air Conditioner's indoor unit is likely due to air humidity after prolonged use. Try increasing the temperature setting and running the unit at a high fan speed.
General| Model Number | M5WM015JR |
|---|---|
| Category | Air Conditioner |
| Refrigerant | R410A |
| Cooling Capacity | 15000 BTU/hr |
| Operating Ambient Temperature | 16-52°C |
Details about indoor unit model nomenclature.
Details about outdoor unit model nomenclature.
Ensures the operating temperature is in the allowable range.
Diagrams showing refrigerant flow for different models.
Details on the operation of the G17 remote controller.
Guidelines and precautions for electrical wiring.
Guidelines for performing refrigerant piping work.
Procedures for vacuuming and charging the refrigerant system.
Important safety warnings and cautions for installation.
Requirements for selecting outdoor unit installation clearance.
Common fault conditions and troubleshooting tips.
Troubleshooting based on refrigerant pressure readings.
Flow charts for diagnosing electrical and refrigerant issues.
To Next Page
