MCQUAY Service Guide Book Handset Operating Guide
8
4.3 G11
Operation Guide
1. “ON/OFF” Button
2. Temperature Setting
• The temperature setting range is from
16°C to 30°C.
• Press both buttons simultaneously to
toggle and from ▲ °C to▼ °F setting.
3. Operation Mode
• Cooling only unit: COOL (
), DRY ( )
and FAN (
).
• Heat pump unit: AUTO, COOL (
), DRY
(
), FAN ( ) and HEAT ( ).
4. Fan speed selection
• Press the button continuously will toggle
the fan speed in the following order: Low
( ) –––: Med ( ) –––: High ( )
–––: Auto
5. ON Timer Setting
6. OFF Timer Setting
7. Automatic Air Swing
• Press the SWING (
) button to activate
the automatic air swing function. Press
again to stop the louver at the desired
direction.
8. Sleep Mode Setting
• This function is available under COOL,
HEAT and AUTO mode.
• When the unit is operating under cooling
mode, the set temperature is increased
by 0.5°C after 30 minutes, 1°C after an
hour, and 2°C after 2 hours.
• When the unit is operating under heating
mode, the set temperature is decreased
by 1°C after 30 minutes, 2°C after an
hour and 3°C after 2 hours.
9. Clock Time Setting
• Press + button to increase the clock time.
• Press – button to decrease the clock
time.
10. Turbo Mode
• Press the TURBO (
) button to achieve
the required set temperature in a short
time.
11. Ionizer
• Press the Ionizer (
) button to activate
the negative Ion function, which will
refresh the indoor air effectively.
12. Personalize Setting
• Press button and hold for 3s to
initiate personalized setting
• Set the individual setting e.g. MODE,
SET TEMP or FAN SPEED and leave for
4s to save the setting into the program.
• 2 groups of settings are allowed to store
in the handset. Press once to activate the
P1 setting, press again to cycle between
P1 and P2.
• Press any key to deactivate the
personalize setting.
To Next Page
Loading...
Need help?
General
