MD Diagnostics RP Check - Page 25

24
Guidance and Manufacturer’s Declaration - Electromagnetic Emissions
The RP Check is intended for use in the electromagnetic environment specified below. The
customer or the user should assure that it is used in such an environment.
Emissions Test
Compliance
level
Electromagnetic environment guidance
RF Emissions CISPR 11
Group 1
The RP Check uses RF energy only for its
internal function. Therefore, its RF
emissions are very low and are not likely
to cause any interference in nearby
electronic equipment.
RF Emissions CISPR 11
Class B
The RP Check can be used in domestic,
light and heavy industrial environments.
Harmonic emissions IEC
61000-3-2
[Not Applicable]
Voltage fluctuations / flicker
emissions IEC 61000-3-3
[Not Applicable]
[See 5.2.2.1 c)
and Figure 1]
The RP Check is suitable for use in all
establishments, including domestic
establishments and those directly
connected to the public low-voltage power
supply network that supplied buildings
used for domestic purposes.
[See 5.2.2.1 c)
and Figure 1]
The RP Check is suitable for use in all
establishments other than domestic and
those directly connected to the public low-
voltage power supply network that
supplied buildings used for domestic
purposes.
RF Emissions CISPR 14-1
Complies
The RP Check is not suitable for
interconnection with other equipment.
RF Emissions CISPR 15
Complies
The RP Check is not suitable for
interconnection with other equipment.