KEEP THIS MANUAL IN A SAFE
PLACE FOR FUTURE REFERENCE.
The recommended maximum weight of
the occupant is 30 lbs on changing table.
Be sure to tighten the cross bar screws now that you have installed to the stationary side. Recheck all screws
and bolts to be sure they are fastened securely.
Before placing your mattress in the crib, you can make your own mattress protector by cutting the cardboard
packing insert to 27” x 51”. Place it on the spring frame under the mattress to extend the life of the mattress.
page 12
STEP 15. Place the pad onto the changer
CAUTION: ANY MATTRESS USED IN THIS CRIB MUST BE AT LEAST 27 1/4 INCHES (69CM)
BY 51 5/8 INCHES (131CM) WITH A THICKNESS NOT EXCEEDING 6 INCHES (15CM).
Please refer to the label (sample below) on the inside face
of the headboard. Record the model/ item number and serial
number of your crib, the name of the store where you made
the purchase, the date of purchase and the wood
nish in
the box to the lower right.
WE WILL ASK YOU FOR YOUR SERIAL NUMBER FOR ALL
WARRANTY AND REPLACEMENT PART REQUESTS. PLEASE
REFER TO THE LAST PAGE OF THIS INSTRUCTION SHEET FOR
WARRANTY INFORMATION. KEEP THIS MANUAL FOR FUTURE
REFERENCE.
Please read the Caution and Warning
Statements insert before using your crib.
SAMPLE LABEL
THIS PRODUCT CONFORMS TO THE
APPLICABLE REGULATIONS OF THE
CONSUMER PRODUCTS SAFETY COMMISSION.
www.themdbfamily.com
CAUTION: ANY MATTRESS USED IN THIS CRIB
MUST BE AT LEAST 27 1/4 INCHES (69CM) BY
51 5/8 INCHES (131CM) WITH A THICKNESS
NOT EXCEEDING 6 INCHES (15CM).
BB. Pad
To Next Page
Loading...
