www.marketdirect.com.au Ph: 1300 494 494
9
Vehicle Electrical Requirements
Brake Controller
All MDC campers and campers require an electric brake controller to be tted to the tow vehicle by law.
There is a wide range of controllers available that are suitable.
Correct Vehicle Wiring for MDC Camper
If your camper is tted with a breakaway system (Cruizer HS, Robson XTT), to comply with national laws on breakaway
systems, you must supply a maintenance charge to the battery/batteries that power the system should it be activated. In
all MDC products, the breakaway is powered by the house batteries in the camper. For this purpose and Anderson plug
connection is tted to all MDC campers on the drawbar. Your vehicle will need to be tted with a power supply to a 50
amp Anderson plug near the towbar so the trailer can be connected. The vehicle only needs to supply power while it is
running so a voltage sensitive relay or switching device may be used to protect the start battery when the car engine is
stopped.
To Next Page
Loading...