10 V2.0
Off: Press Power button more than 2 seconds, until the
instrument "beep" twice, the Power button indicator lights off,
the instrument shut down.
Standby: When device is power on and the projector is
illumed, by short pressing the Power button (less than 0.5
seconds), the device will go to standby mode and the
projector will be turned off.
Wake Up: When device is in standby mode, by short pressing
the Power button (less than 0.5 seconds), the device will beep
and the projector will be illumed
Color: Button to change color.
There are five projection colors to choose. The colors are
cyan, green, natural, red, blue. The default color is cyan.
Size: Button to adjust the size of the projected image.
There are three projection sizes to choose, full size, 2/3 size
and 1/2 size. The default size is full size.
Inverse: Button to change the brightness contrast.
Projected image of the blood vessel becomes brighter, while
the surrounding tissues become dimmed. The projection of
the blood vessel is dim by default.
Mode: Button to change mode.
Short press Mode key (about 0.5 seconds) can achieve
different brightness switching. There are 3 degrees of
brightness. Long press (about 2 seconds) can achieve
switching mode between universal mode and fine detail
mode. Boot defaults to the second degree of brightness and
universal mode.
To Next Page
Loading...
