Need help?Do you have a question about the MDS 58 FS Pro and is the answer not in the manual?
Detailed steps for installing the engine's carburetor and O-ring, ensuring proper fit.
Guidance on correctly positioning the carburetor for an airtight seal by compressing the O-ring.
Procedures for breaking in ringed engines, emphasizing rich mixture for cooling and ring seating.
Break-in process for ABC engines, noting slight differences and shorter duration for piston seating.
Instructions for attaching the muffler using the supplied hardware and bolts.
Recommendations for optimal fuel tank position relative to the engine for consistent operation.
How to choose and install the correct propeller size for initial engine runs and break-in.
Step-by-step guide to starting the engine, including fuel and needle valve settings.
Method for testing and adjusting the low-speed needle for proper idle and throttle response.
Advice on using clean fuel and installing inline fuel filters to protect the engine.
How to use after-run oil to protect engine components from moisture and corrosion.
Guidance on diagnosing and resolving issues causing lean engine operation, possibly O-ring related.
General advice on selecting the appropriate propeller for the engine's application.
Information about the break-in glow plug and suitable replacement options.
Detailed steps for installing the engine's carburetor and O-ring, ensuring proper fit.
Guidance on correctly positioning the carburetor for an airtight seal by compressing the O-ring.
Procedures for breaking in ringed engines, emphasizing rich mixture for cooling and ring seating.
Break-in process for ABC engines, noting slight differences and shorter duration for piston seating.
Instructions for attaching the muffler using the supplied hardware and bolts.
Recommendations for optimal fuel tank position relative to the engine for consistent operation.
How to choose and install the correct propeller size for initial engine runs and break-in.
Step-by-step guide to starting the engine, including fuel and needle valve settings.
Method for testing and adjusting the low-speed needle for proper idle and throttle response.
Advice on using clean fuel and installing inline fuel filters to protect the engine.
How to use after-run oil to protect engine components from moisture and corrosion.
Guidance on diagnosing and resolving issues causing lean engine operation, possibly O-ring related.
General advice on selecting the appropriate propeller for the engine's application.
Information about the break-in glow plug and suitable replacement options.
To Next Page
General