11 12
mepower.com
clean and store sleek
1. Turn off the system by touching the power button on the base unit.
The light indicator should turn from green to orange.
2. Place the applicator in its cradle on the base unit and unplug the
electric cable from the electrical outlet.
3. Clean the light output window with a non-alcohol based wet wipe or
soft tissue.
4. Clean the outside surface of the sleek device using ONLY a dry soft
cloth or a non-alcoholic based wet wipe.
5. Store sleek in a cool and dry place AWAY from the reach of children.
travel with sleek
The system is designed with universal voltage. That means that you can
use the system all over the world. You will need to use an adaptor for the
plug, since electric wall outlets vary by country. Make sure that system
does not get wet while traveling. Do not use it in a wet environment. It is
recommended to protect your device while traveling.
troubleshooting
device
Indicator What does it mean? How to react
No lights are on Power cable is not
connected
Connect power cable
Indicator What does it mean? How to react
All energy setting
indicators are
blinking (high-
medium-low)
No energy level was
selected
Select an energy
level and activate the
applicator. The applicator
fan will start blowing
indicating that the device
is active.
Activation button
on the applicator
is blinking
The energy level
was selected but the
applicator activation
button was not
pressed yet
Press the applicator
activation button. The
applicator fan will start
blowing indicating that
the device is active.
Power button is
blinking in orange
color
An error has been
detected
Reset the system by
turning it off and on
again. If problem persists,
disconnect power cord
and wait until all lights
are off (several seconds).
Then reconnect the
power cord and turn on
system. If error light is
still on, try moving to a
cooler area with a room
temperature of less than
30ºC/ 86ºF and restart
the system.
To Next Page
Loading...
