Meaco 7000 - Trouble Shooting; No power to the machine; Power button does not work; Machine turned on but compressor does not work

19 [EN]
Trouble Shooting
---------------------------------------------------------------------------------------------------------------------------------------
Trouble
Cause
Solution
No power to the machine
There is no power to the unit.
Plug in the unit and check the
power outlet.
The ON/OFF button has not
been pressed.
Press the ON/OFF button.
Power button does not work
Check the instructions above.
If it still does not work please
contact Meaco.
Machine turned on but
compressor does not work
The compressor does not turn
on for the first three minutes of
operation.
Wait three minutes.
Remote control does not
work
The battery needs changing or
the remote is out of range.
Replace the battery in the
remote or stand closer to the
machine.
Increased noise level
The filter is dirty.
Clean the filter (see page 16).
The air inlet is blocked.
Make sure there is enough space
around the unit and that the air
inlet is not blocked by a wall,
furniture or curtains.
The unit is being used on
uneven floor.
Place the unit on a level surface.
Too noisy to use in a
bedroom
Pre-cool the room.
Run the unit for several hours
before you go to bed with the
curtains and door closed in order
to pre-cool the room.
Fan speed does not change
The unit is in Sleep Mode or
Dehum Mode.
Change operation mode if
required (see pages 10 and 11).
Cooling is not effective
Room size is too large.
Check whether the air coming out
of the unit is cool and either let
the unit run for longer or use it in
a smaller room. Keep all doors
and windows shut.