Mec 300E ATA User Manual

Page 1 Version 2
OWNERS MANUAL
FOR MEC 300E ATA
PLEASE READ AND FULLY UNDERSTAND THE INSTRUCTIONS PRIOR TO SETTING OR
TUNING THE MACHINE.
CAUTION: ANY MEC CLAY TARGET MACHINE MUST BE IN THE DISARMED STATE WITH THE
BATTERY DISCONNECTED PRIOR TO MAKING ANY ADJUSTMENTS, LOADING THE CLAY
TARGETS OR TRANSPORTATION OF MACHINE.
Step 1 – Securely set the machine in the trap house. See below for the correct way to install the
MEC machine into the trap house. IF NOT FASTENED SECURELY, SERIOUS INJURY AND/OR
DAMAGE TO MACHINE CAN OCCOUR!!!
DO NOT CONNECT THE POWER. Ensure that the machine is in the DISARMED/SAFE position.

Mec 300E ATA Specifications

General

Brand	Mec
Model	300E ATA
Category	Accessories
Language	English

Summary

Initial Setup Procedures

Step 1: Secure Machine in Trap House

Securely install the MEC machine into the trap house to prevent injury or damage.

Understanding the Control Box

Steps 4-7: Operational Checks and Safety

Perform safety checks, disarm, visually inspect, and prepare for initial operation.

Adjusting Machine Elevation

Adjusting Machine Tilt/Angle

Centering the Field

Steps 10-14: Field Centering Adjustments

Detailed steps for adjusting the machine to center the clay's trajectory down the field.

Final Adjustments and Preparation

Step 15: Adjust Throwing Distance

Fault Finding Mechanical

Machine Breaks Clays

Troubleshooting steps for the machine breaking clays, focusing on loading cycle and knife edges.

Machine Throws Clays with Issues

Carousel Does Not Rotate

Fault Finding Electrical

Machine Does Not Arm

Checks for battery, toggle switch, breaker, relay, and fuse issues preventing arming.

Machine Runs in DISARM, Not ARM

Machine ARMS, Won't Fire on Pull Cord

Trap Fires by Itself

Identifying causes for the trap firing unintentionally, like faulty pull cords or limit switches.

Correct Position of Machine Base in Trap House