8
www. mechmaxx.com
SERVICE AND MAINTENANCE
SERVICE AND MAINTENANCE
SERVICE
SEASON MAINTENANCE
MAINTENANCE
FLUIDS AND LUBRICANTS
GREASING
NOTE:The operator shall put on gloves and use suitable
tools before changing blade.
1.Greas:
Use multi-purpose lithium based grease.
2.Gear Box Oil:
Use N46 drive &hydraulic dual-purpose oil or equivalent
for all operating
Each Gearbox Capacity: 0.85 liter
3.Storing Lubricants:
Your machine can operate at top efficiency only if clean
lubricants are used. Use clean containers to handle all
lubricants. Store them in an area protected from dust,
moisture and other contaminants.
By following a careful service and maintenance program
for your machine, you will enjoy many years of trouble-free
operation.
The period recommended is based on normal operating
conditions. Severe or unusual conditions may require
more frequent maintenance.
• Check and screw all nuts and bolts in connection parts.
• Check the blade and fixing parts every day and replace
the damaged parts if they are found damaged. Don't
install damaged, worn and unbalanced blade.New
sleeve shall be used to replace the worn fixing parts on
the blade.
8 HOURS OR DAILY MAINTENANCE
• Use a hand-held grease gun for all greasing.
• Wipe grease nipple with a clean cloth before greasing,
to avoid injecting dirt and grit.
• Replace and repair broken nipple immediately.
• If nipples will not take grease, remove and clean
thoroughly. Also clean lubricant passageway. Replace
nipple if necessary.
• Check the oil in gearbox. Fill them up to line if it's
necessary.
• Press butter in each oil nipple three to five times.
• Clean the implement; take away all grass and mud.
• Check the machine as below beside the terms of daily
maintenance.
• Check the oil in gearbox; replace it if it is bad.
• Check the bearings of blade spindles whether mud and
water have been enter because oil seals are damaged,
if it's so, disassemble and clean them and replace them
if it is necessary. And then press butter into them.
• Check the distance between bearings and gears. Adjust
them if it's necessary.
ANNUALLY MAINTENANCE
• Cleaning mud and grass on the machine thoroughly.
• Check all clearance between bearings and gears if you
have replaced them.Please run it without load for 3-5
minutes.
• Check and clean blade axles. Replace oil seals and
press butter into them.d
• Check all blades, replace then if they are wear-out or
damaged.
• Repair the side skirts; let them to original technical
condition. Replace damaged or broken protective devic-
es.
• Remove the driving shaft from the machine. Pull the
machine driving shaft apart. Check and replace any
components that are damaged or worn. Install the drive
line on the machine. The machine driving shaft should
telescope easily and the guard turn freely on the shaft
• Let the oil in gearbox drain out thoroughly. Check and
clean it. Fill new gear oil up to the dedicated oil level.
• The oil shall be drained off after 50 hours of using time.
Then the oil shall be drained off every 250 hours. One
time every year at least.
All maintenance, repairing, cleaning and
lubricating shall be conducted when the
tractor and motor are stopped and the key
is taken away.
Check the oil level only when the unit is
cold and the machine is on the level.
To Next Page