9
www. mechmaxx.com
SERVICE AND MAINTENANCE
STORAGE
OPERATION AFTER STORAGE
• The draining procedure is as follows: remove the drain-
ing bolt under the gear box, so that the oil drains off.
After the oil is drained off, put back the cover and fill the
gear oil up to the dedicated oil level.
The machine inside and outside shall be cleaned carefully
so as to avoid corrosion.
Don't spray water on the rolling bearing if you clean the
machine with high pressure sprayer.
Check and clean the universal joint, driving belt press
roller, or replace them if they are not in good state.
Spread oil on all parts required.
Receat the parts rubbed and damaged for anti corrosion.-
Store the machine in a dry, level area. Support the frame
with planks if require.
Before the machine is started up, check the following
items regularly:
Check oil level and add it if not enough.
Check and tighten all screws and nuts;
Check the regulated state of the machine.
Check the blade state.
Check the air hole on the gearbox. If it is blocked, clean or
open the hole with compressed air.
Don't spread oil or grease on the driving belts. If there is
oil or grease on the belts, wipe the belts, in case the belt
sliding and wearing occur.
Check all tightening parts and replace them if necessary.
Don't remove the protective parts on some points and
protect the machine.
Check the machine every 10 hours. Repair
the damaged parts or replace the blade
according to the manufacturer's recom-
mendation, to keep the machine balanc-
ing.
In the case of vibration, stop the machine
and check the blade. If the blade breaks or
is damaged, replace it with same type of
the blade. If the machine vibrates still,
send the machine to the authorized
repairer.
Don't forget to disconnect the generator
cable and batteries when welding on the
machine, while the machine is coupled
with the tractor.
LUBRICATION
Gearbox
Type of Lubrication: SAE 90W Gear Lube
AS
REQUIRED
Check oil level in gearbox by removing the plug located on
the right hand side. Oil should be level with bottomof plug
hole. Add oil if necessary by removing top fill plug and side
plug. Add oil until it flows from side plug hole.
Do not overfill!
IMPORTANT: Mower should be level when checking oil in
gearbox!
To Next Page