9
CHAPTER 2. INSTALLATION OF MACHINE
The machine should be installed in a well-ventilated room protected from dust and direct contact with
atmospheric agents.
The machine must remain packed until the final installation at the place of employment.
2.1 ENVIRONMENTAL CONDITIONS OF INSTALLATION SITE
The environmental conditions in which the machine must be installed must follow these characteristics:
- Temperature: +5/+40° C, with the average temperature not exceeding 35°C over a period of 24 hours.
- Relative humidity: from 30% to 95% in the absence of condensation
- Water and heat sources at safe distance from the machine
- Well-dimensioned flat and stable surface
2.2 TRANSPORT AND HANDLING
The machine is delivered completely assembled and packaged with a fumigated wooden case and and fixed
onto a wooden-pallet.
Transport and handling of machine must be carried out under safety conditions using appropriate means of
transport.
To lift and handle the pallet or the case use a suitable fork lift truck; the lifting forks are to be introduced in the
pallet as shown in Pict. 2.1 and 2.2.
Separate the different materials according to material type and recycle them in accordance with relevants
legislations.
Pict. 2.1
The machine is placed onto a wooden-pallet
(Pos.1) and it’s locked by a locking device (Pos.2)
and two threaded bars Pos. 3
The lifting forks are to be introduced in the
pallet as shown in Pict. 2.1 (Pos.4)
To Next Page
Loading...
