What to do if my Mediana YM1000 monitor is operating on battery power even when connected to AC?
If your Mediana Medical Equipment monitor runs on battery even when connected to AC power, ensure the power cord is properly connected. Also, check if other equipment on the same AC circuit has power. The monitor will operate from its internal battery if there are doubts about the integrity of the AC power source.
How to troubleshoot disruption in Mediana YM1000 Medical Equipment, like erratic readings or incorrect functioning?
To troubleshoot disruptions in your Mediana Medical Equipment, such as erratic readings or cessation of operation, try turning nearby equipment off and on to isolate the cause. You can also reorient or relocate any interfering equipment, or increase the separation between the interfering equipment and the affected device.
What to do if my Mediana Medical Equipment doesn't respond to the Power On/Off switch?
If your Mediana Medical Equipment does not respond to the Power On/Off switch, it could be due to a blown fuse. Notify service personnel to check and replace the fuse if needed. If running on battery, the battery might be missing or discharged. If discharged, charge the battery; refer to the Battery Operation section.
Important safety information related to general use of the YM1000 monitor.
Alerts to potential serious outcomes (death, injury, adverse events).
Alerts to exercise care for safe and effective use, grounding, accuracy.
Identifies and explains front panel controls and symbols.
Details rear panel components and their functions.
Details the functions of the YM1000 controls.
Procedures for connecting the AC power cable to the monitor.
Guidelines for connecting NIBP hoses, cuffs, and SpO2 cables.
Explains how the monitor operates using internal battery power.
Steps for charging a low or dead battery.
Details on the monitor's power-on self-test procedure.
Explains MANUAL, AUTO, and STAT modes for NIBP.
Setting initial inflation pressure for NIBP measurements.
Details Predictive and Monitored temperature measurement modes.
Taking a predictive oral measurement.
How to set alarm limits for vital signs.
Troubleshooting steps for common issues like no response or display problems.
Detailed specifications for NIBP, SpO2, Pulse Rate, and Temperature.
General| Category | Medical Equipment |
|---|---|
| Model | YM1000 |
| Manufacturer | Mediana |
| SpO2 | Yes |
| NIBP | Yes |
| Respiration | Yes |
| Temperature | Yes |
| Pulse Rate | Yes |
| Parameters | ECG, SpO2, NIBP, Respiration, Temperature, Pulse Rate |
| Battery Life | Up to 4 hours |
| Power Supply | AC 100-240V, 50/60Hz |
| Type | Patient Monitor |
| Display | TFT LCD |
| Battery | Rechargeable Lithium-ion |
To Next Page
