To Next PageTo Next Page
Need help?Do you have a question about the MediaSonic HUR1-SU3S2 and is the answer not in the manual?
General| Model | HUR1-SU3S2 |
|---|---|
| Category | Enclosure |
| Interface | USB 3.0 |
| Material | Plastic |
| Power Supply | External Power Adapter |
| Type | External |
| Form Factor | 3.5 inch |
| Supported Drive Types | HDD, SSD |
| Supported HDD | 3.5 inch SATA HDD |
Explains the LEDs that indicate the selected RAID mode and their status.
Guide on selecting RAID modes using the DIP switch configuration table.
Guidance on physically mounting the hard drives into the enclosure's rack.
Instructions for reinserting the rack, connecting power, and data cables.
Reiteration to set the RAID mode using the DIP switch as detailed previously.
Procedure to confirm the selected RAID mode using the confirmation button and LEDs.
Steps to close and secure the enclosure after all internal installations are complete.
Explains RAID 1 (Mirroring) for data redundancy and backup.
Detailed guide for setting up Single Mode with two simple volumes in Windows.
Warns about potential data loss when changing RAID modes and advises backups.
Informs users that installing both HDDs in any RAID mode will format all data.
Specifies that the eSATA port must support Port-Multiplier for proper function.
