Service Manual - medifa 8000
The Radioscopy Operating Table medifa 8000 has been manufactured according to the state of the art as well
as to the valid safety specifications and requirements.
Nevertheless, improper handling and/or damages on the radioscopy operating table can lead to safety hazards
for the user and/or other persons and tangible assets.
Only start running the radioscopy operating table when in perfect condition. This table has been solely desig-
ned for normal use. Operators should keep in mind to handle the table in compliance with the safety rules and
recommendations as listed in this manual in order to avoid any hazards which may occur from improper hand-
ling. Any defaults which may affect the safety have to be repaired immediately!
The table comes with conductive double castors, conductive upholstery and an equipotential bonding.The ra-
dioscopy operation table can be used in a Zone M - given the area is equipped with a conductive floor.
Always keep this manual close at hand. Please notice as well all legal and further guidelines and regulations
for accident prevention and pollution control.
Do not replace, change or repair any devices of the above mentioned table without the authorization of the ma-
nufacturer. All repairs and maintenance services need to be carried out by the manufacturer or by authorized
personnel.
Spare parts need to be in accordance with the requirements of the manufacturer. Original spare parts always
guarantee the proper running of the radioscopy operation table.
Keep the mandatory deadlines for recurring controls as stated in this service manual!
Think of an environnement friendly disposal of equipment and faulty parts!
Think of a barrier free surrounding before car-
rying out a downward or tilting motion!
DANGER OF TILTING!
Avoid collisions between parts of the table top and the
column, when carrying out the following adjustments:
Height adjustment (downwards)
Tilt adjustment
I. Safety Instructions
2
To Next Page
Loading...
